油田压裂返排液处理技术实验研究

油气井压裂作业过程中产生的压裂返排液已成为当前油田水体的主要污染源之一。文章对吉林油田公司压裂返排液处理工艺进行了实验研究。结果表明:在采用絮凝、微波强氧化、活性炭毡处理、纳滤/反渗透集成处理工艺后,压裂返排液CODCr可以达到GB 8978-1996《污水综合排放标准》一级标准要求。该研究为压裂返排液处理装置的设计和现场实施提供了实验基础。     

3m直径煤油池火灾火焰特性的数值研究

为了预测油池火灾的火焰特性,采用CFD模拟技术开展静风状态下3 m直径煤油液池的火灾场景模拟,探讨火焰温度、火焰羽流速度、辐射热通量、燃烧产物质量分数等油池火焰特性参数随高度的变化关系;并结合火焰形态分布,提出一种4区域模型,即将湍流扩散火焰划分为油气混合燃烧区、燃烧火焰区、烟尘区和热烟气区来分析燃烧气流在不同高度的实际物理化学特性。此外,通过经验公式和CFD模拟2种方法分别计算出3 m直径煤油池火灾的火焰高度、火焰表面的辐射通量及热辐射破坏半径,并对计算结果进行比较分析,结果表明:2种方法可互相补充完善,有助于池火灾的热辐射危害性评估。     

油田作业废水处理技术研究进展

文章讨论了作业废水的组成与特点,并对近年来钻井废水处理工艺,酸化废水处理工艺,压裂废水处理工艺进行了总结与评述。根据作业废水的处理现状,对未来作业废水的处理技术进行了展望。油田废水处理主要向以下三个方面发展:开发新型处理药剂;建立高效处理工艺流程;从污水源头开始控制。     

微电解-Fenton联合工艺预处理煤层气井压裂废水

利用Fenton强化微电解工艺对煤层气井压裂废水展开预处理研究,以COD去除率和可生化性(B/C)为考察指标,单独工艺正交实验结果表明pH为3、反应时间为90 min、铁碳体积比为1.5∶1和pH为4、反应时间为80 min、H2O2投加量为4 mL/L分别是微电解与Fenton反应的最优条件,各可获得48.1%和44.9%的COD去除率。在最优条件下进行微电解-Fenton联合运行实验,连续61 h内COD去除率均稳定在65%以上,B/C由0.158上升到0.3以上,有利于后续生化处理的运行。     

两级氧化法处理油田压裂返排液

采用两级氧化法处理油田压裂返排液。在次氯酸钠、次氯酸钙、过氧化氢、高锰酸钾4种氧化剂中，次氯酸钠的氧化效果最好。以次氯酸钠作为一级氧化剂，进行一级氧化处理;再分别采用次氯酸钙、过氧化氢、高锰酸钾进行二级氧化处理。在次氯酸钠加入量为40mL/L、一级氧化反应时间为30min、二级氧化反应时间为30min、初始废水COD为3976mg/L的条件下，二级氧化剂过氧化氢、次氯酸钙、高锰酸钾的最佳加入量分别为80，40，40mL/L，对应的COD去除率分别为82.60%，71.50%，83.50%。     

Numerical simulation of an array of fences in Saemangeum reclaimed land

This paper discusses about the quantitative effect of windbreak fences on wind velocity in the reclaimed land at Saemangeum in South Korea. Windbreak fences were constructed in the reclaimed land to reduce the wind velocity to prevent the generation and diffusion of dust. However, up to this time, no in-depth studies were conducted to quantitatively measure the effect of the windbreak fences on wind velocity thus an optimum windbreak structure is not yet determined. Using CFD simulations, the effects of fence porosity, fence height, and the distance between the adjacent fences were investigated. A wind tunnel experiment was initially conducted and data gathered were used to develop the CFD models. From the experiments and CFD simulations, the overall percentage difference of the measured velocities was 7.20% which is generally acceptable to establishing the reliability of the CFD models. The reduction effect on wind velocity was measured in between the adjacent fences up to a height of 0.6 m from the ground surface. In terms of porosity ( = 0, 0.2, 0.4, 0.6), 0.2 was found to be the optimum value. Conversely, the effect of fence height (0.6, 0.8 and 1.0 m) showed no significant difference; therefore, 0.6 m height is recommended. In addition, the reduction effect of distance between the adjacent fences (2, 4 and 6 m) on wind velocity having a 0.2 porosity has decreased to about 75% regardless of the distance. In the case of the reclaimed land in Saemangeum, a decrease of 75% can prevent the generation and diffusion of dusts. However, the source of dusts is very large. Therefore, constructing an array of windbreak with 6 m distance between them is deemed necessary.     

计算流体力学(CFD)中的迭代法及其并行计算方法

应用计算流体力学 (CFD)方法分析事故原因已被广泛采用 ,笔者针对事故理论分析和流体计算过程中 ,运用CFD方法所存在计算量大的问题 ,分析和讨论了几种古典迭代法及其并行计算方法     

烟气扩散的CFD数值模拟

运用商业CFD软件Fluent模拟计算小尺寸下的简单烟气扩散规律.将结果用正态分布假设下的高斯烟羽模型验证.证明该软件模拟烟气扩散问题的可行性.